Panasonic AW-UE20KP - Frequency and Installation Options; Preset Speed Settings

92
Frequency
Set the frame frequency – 50Hz, 59.94Hz, or 60Hz.
When the frequency is switched, “Format” is set as following:
Frequency 50Hz 59.94Hz 60Hz
Format
HDMI
2160/25p
1080/50p
1080/25p
720/50p
1080/50i
2160/29.97p
1080/59.94p
1080/29.97p
720/59.94p
1080/59.94i
2160/30p
1080/60p
1080/30p
720/60p
1080/60i
Format
SDI
1080/50p,
1080/25p,
720/50p
1080/50i
1080/59.94p,
1080/29.97p,
720/59.94p
1080/59.94i
1080/60p,
1080/30p,
720/60p
1080/60i
Factory settings: 59.94Hz

Others
Click [Set] button to save the configuration
Install Position
[Desktop, Hanging]
“Desktop” or “Hanging” is selected here as the method used to install the unit.
When “Hanging” has been selected, the top, bottom, left and right of the images will be reversed and
up/down/left/right control for panning and tilting will also be reversed.
Factory settings: Desktop
Preset speed table
[Slow, Fast]
Set the preset speed table (Slow, Fast).
During preset playback, preset actions are performed at Preset Speed (1 to 30) values that are based on the table
set here.
Slow: Set the preset speed table to “Slow”.
Fast: Set the preset speed table to “Fast”.
Factory settings: Fast
Preset speed
[1~30]
There are 30 preset pan-tilt operation speeds when regenerating the camera direction and other information which
are registered in the preset memory.
[Note]
If a high value is selected for the Preset Speed setting, the image on the screen may shake when operation stops.
Factory settings: 20