Operating Instructions
63
2.5 Encrypt the Camera Image in Transport Mode
The camera can encrypt the image using IPsec transport mode.
Note
If you use IPsec, refresh interval slows down.
1. Click [IPsec] on the Setup page.
2. Click Camera in the Transport column.
• If you use transport mode in E-mail or FTP transfer, click No. in the Buffer/
Transfer c ol u mn .
Note
To display Alarm Log, set Alarm 1, Alarm 2 or Motion Detection for Trigger
Setting and check [Enable].
3. Enter each parameter in the data field.
The display shows that
the communication is in
HTTP and any people can
access the camera if they
have the pre-shared key.
Set up these settings to
transfer images in
transport mode (see page
126).
Set to use Alarm Log (see page 131).
To Next Page
Loading...
