NTSC/PAL system select To switch PAL/ NTSC
alternately.
The display before execution leaves. When the power is on (E-
E mode), press [STOP]
and [OPEN/CLOSE]
simultaneously for five
seconds.
Forced power-off When the power button
is not effective while
power is ON, turn off
the power forcibly.
*When Timer REC is
ON or EXT-LINK is
ON, execute “Forced
Power-off” after
releasing Timer RECor
EXT-LINK.
Action:
The tray will open, and
the power will turn off.
Display in P-off mode. Press [Power] key over
than 10 seconds.
Aging Perform sequence of
modes as * Aging
Description shown
below continually.
Display following the then mode. When the power is ON,
press [CH DOWN], TIME
SLIP] and [OPEN /
CLOSE] simultaneously
for over five seconds and
less than 10 seconds.
*The [REC MODE]
should be set to EP or LP.
*Whenthe unit has hung-
up because of pressing
keys for over 10 seconds,
once turn off the power,
and re-execute this
command.
“When releasing Aging
mode, press [POWER]
key.
Demonstration lock/
unlock
Ejection of the disc is
prohibited.
The lock setting is
effective until
unlocking the tray and
not released by “Main
unit initialization” of
service mode.
*When lock the tray.
“LOCK” is displayed for 3 seconds.
When the power is on,
press [STOP] and
[POWER] keys
simultaneously for five
seconds.
*When unlock the tray.
“UNLOCK” is displayed for 3 seconds.
When the power is on,
press [STOP] and
[POWER] keys
simultaneously for five
seconds.
To Next Page
Loading...
