Basic Transmission Settings
35
Basic Operations
The Original setting is useful when sending photographs or illustrations with gray tones. Your machine is
preset to "TEXT". You can select either "TEXT/PHOTO" or "PHOTO" mode.
The Verification Stamp helps you to confirm successful transmissions by stamping the bottom of each
successfully transmitted page with a small mark.
NOTE
1. When you select TEXT/PHOTO, or PHOTO, your machine will automatically select Fine
Resolution.
2. When you store a document in memory, the Verification Stamp will stamp on the document if it
is successfully stored in memory. In this case the Verification Stamp is not a confirmation that
the document was successfully transmitted. If you wish to disable the use of the Verification
Stamp when storing document in memory, change the setting of Fax Parameter No. 28. (See
page 30)
3. To change the preset Verification Stamp position, change the setting of Fax Parameter No. 04.
(See page 29)
Original (Text/Photo)
Verification Stamp
for text only originals
for text and photo originals
for photo or illustration originals
To Next Page
Loading...
