Sending Documents
53
Voice Mode Transmission
Basic Operations
On-Hook Dialling
For On-Hook Dialling, follow the steps below.
Make sure that the FAX/EMAIL lamp is ON. If not, press to select the "FAX/EMAIL" mode.
NOTE
1. If you need a special access number to get an outside line, dial it first then press to
enter a pause (represented by a "-") before dialling the full number.
Ex: 9 PAUSE 5551234
2. If you are using Pulse dialling and you wish to change to Tone dialling in the middle of dialling,
press (represented by a "/").
The dialling mode will be changed from Pulse to Tone after dialling the digit "/".
Ex: 9 PAUSE * 5551234
1a
Place original(s) face up on the ADF.
or
ENTER STATION(S)
THEN PRESS START 00%
1b
Place a book or an original face down on the Platen Glass.
Press to select the original size.
2
You will hear dial tone through the monitor speaker.
* MONITOR *
❚
3
Dial the telephone number from the keypad.
Ex:
* DIALLING *
5551234
❚
4
When you hear a beep,
ON LINE * XMT *
1
2
ORIGINAL SIZE
5 5 5 1 2
3
4
PAUSE
To Next Page
Loading...
