FP Web-Server V2.11
3.7 Transfer a Configurator Project to the FP Web-Server
39
3.7 Transfer a Configurator Project to the FP Web-Server
With [FIND] the network is searched for all FP Web-Servers. A list of all FP Web-Servers found
will be displayed. Please select the ID number of the respective FP Web-Server (double-click or
press <ENTER>).
If the FP Web-Server is put into operation for the first time (or a new version of the Configurator
was installed), please initialize the FP Web-Server ONCE before transferring the project, i.e.
click [INITIALIZE] and answer the safety request with [YES].
As there are HTML pages required for this initial test, the checkbox "Web files" should be
activated. With [SEND] the project (configuration plus HTML pages) can be transferred to the
respective FP Web-Server.
Please click [REBOOT] after transmission. Wait a little bit and the click [FIND] again to make
sure that the FP Web-Server is online again and to find out which IP address it is using.
Comments:
• Please memorize the IP address for the following tests with the browser below.
• If the FP Web-Server was configured with the wrong fixed IP address, a query with
[FIND] will result in an error message.
• In this case click [YES]. By doing that the FP Web-Server is set to the IP address
entered in the current Configurator project. After a short waiting period, click [FIND]
again.
To Next Page
Loading...
