Panasonic GT32-R

2-18
2.3 Connecting to Screen Creation Tool GTWIN
2.3.1 TOOL Port
Pin No.
Name
Abbre.
Signal direction
1
Signal ground
SG
-
2
Send data
SD
GT→External device
3
Receive data
RD
GT←External device
4
Not connected
N.C.
-
5
+5 V
(+5V)
-
Note:
 The +5V of Pin 5 is reserved for the FP Programmer II. It should not be used for any other application.
If using it, there is a restriction on the ambient temperature. The pin 5 of GT01 is N.C.
2.3.2 USB Port
USB connection
Communication with our software such as GTWIN becomes available by connecting to a PC with a USB
cable.
Functions enabled by USB connection
 Through function using our PLCs
 Screen transfer
Note: If more than one programmable display unit or AE20 are connected to a PC using the USB
port, the communication is not available.