3-8
3.1.9 GT02 / GT02L / GT03-E / GT12 Installation Method
Secure the GT12 or GT02 to the installation panel using the two fittings and four dedicated screws
provided with the unit.
1. Place the GT main unit in the installation panel.
2. Insert the fittings into the grooves provided in the GT main unit, and tighten the screws to
secure the GT main unit to the installation panel.
Note: - The cross slot screwdriver No. 1 must be used.
- Tightening torque: 0.2 to 0.3 N m
- Tightening the screws too hard can cause deformation of the front panel, so that the touch
switches will not function properly.
To Next Page
Loading...
