- 34 -
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 70% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ /
Quick Start will not work if there is no SD card inserted.
≥
Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to or .
1 Set [QUICK START] to [ON].
2 Close the LCD monitor.
The status indicator A flashes green and the unit goes into
Quick Start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ Quick Start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, time for Quick Start may be
longer than 0.6 seconds.
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY
(BATT)] (l 33)/[ECONOMY (AC)] (l 33), close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
Touch screen operation, starting and stopping of recording and unit on/off can be confirmed
with this sound.
2 Beeps for 4 times
When an error occurs. Check the sentence displayed on the screen. (l 140)
[QUICK START]
[ON]/[OFF]
[ALERT SOUND]
/ /[OFF]
(Volume low)/ (Volume high)
HC-V707M
To Next Page
Loading...
