56
VQT1U19
Built-in flash
When the button is pressed, the flash is activated and the
picture will be recorded. Use the built-in flash in order to record
still pictures in dark places.
Select the menu. ( 24)
[RECORD SETUP] [FLASH] [AUTO] or [ON]
! This function’s default setting is [AUTO].
! When the button is pressed halfway, the flash indicator will
appear in the bottom left corner of the screen.
[ON]: #
[AUTO]: #A
[OFF]:
! When [AUTO] is set, the ambient brightness is automatically
detected, and the flash will activate only when necessary. (If the
flash is not necessary, the [#A] indicator will not appear when the
button is pressed halfway.)
# To adjust the brightness of the flash
Select the menu. ( 24)
[RECORD SETUP] [FLASH LEVEL] desired setting
[#"]: Less brighter
[#&0]: Normal
[#']: Much brighter
Red eye reduction
Reduces the phenomena where human eyes become red from
flashes.
Select the menu. ( 24)
[RECORD SETUP] [RED EYE] [ON]
Shutter sound
You can add a shutter sound when recording still pictures.
Select the menu. ( 24)
[RECORD SETUP] [SHTR SOUND] [ON]
! This function’s default setting is [ON].
Auto slow shutter
You can record bright pictures even in dark places by slowing
the shutter speed.
! The intelligent auto mode is set to [OFF]. ( 46)
Select the menu. ( 24)
[ADVANCED] [AUTO SLOW SHTR] [ON]
! The shutter speed is adjusted between 1/25 and 1/250 depending
on the surrounding brightness. (When adjusting the shutter speed
manually, it can be adjusted between 1/25 and 1/8000.)
! If [AUTO SLOW SHTR] is set to [OFF], then the shutter speed will
be set between 1/50 and 1/250. (When adjusting the shutter
speed manually, it can be adjusted between 1/50 and 1/8000.)
Function Effect/Setting method
To Next Page
Loading...
