3.2 Connecting to the LAN
Information about IP Proprietary Telephones 25
3.2.2 Connecting the IP Proprietary Telephones
When an IP-PT is connected to the LAN and power is supplied for the first time, you will be prompted to set
network parameters. The network parameters must be set to the IP-PT before it can be used. Refer to "4.2
Programming the IP Proprietary Telephone" for instructions.
Connecting an IP-PT to a Switching Hub
When connecting an IP-PT to the LAN, connect it to a switching hub.
Notes
• Use an Ethernet straight cable with an RJ45 connector to connect the IP-PT to a switching hub.
The cable should be a 100BASE-TX CAT5 (Category 5) or higher cable.
• When using the VLAN feature on the network, make sure that the switching hub to be connected
complies with IEEE 802.1Q and is configured for VLANs. In addition, the port of a switching hub
that the IP-PT is connected to must be set to "Trunk" port, to allow VLAN tagging. Consult your
network administrator for details.
To a switching hub
Ethernet Straight Cable
LAN
To Next Page
Loading...
