Control Panel and LED Indicators
LED (Red)
Shows the scanner’s status.
LED (Green)
Shows the scanner’s status.
Power key ( )
Skip key (Skip)
• If you press this key when a double feed occurs, the document that was detected as a double feed will
be scanned, and scanning will continue.
• If you press this key after a dog-eared document is detected and scanning pauses, the document will
be scanned, and then ejected from the scanner. Scanning will continue after the dog-eared document
is scanned and ejected.
Start/Stop key (Start/Stop)
• If you set [Wait Key] for "Manual Feed Mode"
*1
in your application software, pushing this key starts
scanning.
• During scanning, pushing this key stops scanning.
• If you press this key when a double feed occurs, the document that was detected as a double feed will
not be scanned. Scanning will stop.
• If you press this key after a dog-eared document is detected and scanning pauses, the document will
be ejected from the scanner without being scanned. Scanning will stop.
*1
For details on "Manual Feed Mode", refer to the help for ICP.
Operating Manual 9
Location of Controls
To Next Page
Loading...
