4.1.1 [Scanner Status] and [Error Code]
The messages and error codes that are displayed here show the scanner status.
For more details on the error codes and messages, refer to 5 Scanner status message table.
4.1.2 [Scanner Information]
The following scanner information is displayed under this menu.
• Model
• Firmware version
• Memory
(For KV-S7065C, KV-S3065CW, and KV-S3065CL only)
Total memory size
• Front Memory, Back Memory
(For KV-S4085CW, KV-S4085CL, KV-S4065CW, and KV-S4065CL only)
Total memory size for the front and back memory
• Type of interface
STI SCSI: SCSI (when the included scanner device driver is used)
ASPI SCSI: SCSI (when the ASPI driver is used)
STI USB (1.1): USB Full Speed
STI USB (2.0): USB 2.0 Hi-Speed
• Terminator enable or disable (only with SCSI connection)
(For KV-S2046C and KV-S2026C only)
• Pre-Imprinter enable or disable
(For KV-S7065C, KV-S4085CW, KV-S4085CL, KV-S4065CW, KV-S4065CL, KV-S3065CW,
KV-S3065CL, KV-S2048C, and KV-S2046C only)
• Post-Imprinter enable or disable
(For KV-S4085CW, KV-S4085CL, KV-S4065CW, KV-S4065CL, KV-S3065CW, and KV-S3065CL only)
• Compatible mode, model
(For KV-S7065C, KV-S3065CW, and KV-S3065CL only)
4.1.3 [Sleep Mode...] button
Press this to open the sleep mode dialog box.
For more details, refer to 4.2 [Sleep Mode] setting.
4.1.4 [Clean Imprinter] button
Press this to spray the imprinter ink. Use it when the imprinter nozzle has clogged.
It can be enabled only when the imprinter is installed.
When cleaning the imprinter, do it after closing the imprinter’s door.
12 User Utility Reference Manual
4.1.4 [Clean Imprinter] button
To Next Page
Loading...
Need help?
General