6.3.3.3 Using the Mixed Batch Card Guide
Set paper documents on the feed tray, and a card on the mixed batch card guide respectively.
• The card set on the mixed batch card guide is fed after completing the paper document scanning.
• For details about the compatible card types for this unit, refer to "6.2.1.2 Compatible Card" (page 23).
• Set the card in landscape orientation.
• Ensure that the embossed portions of cards do not stick together.
• A maximum of 3 cards can be set in the mixed batch card guide.
• If acceptable results cannot be obtained, try changing the scanning orientation or reversing the scan face
of the card, and then perform scanning again.
Note
• When using the mixed batch card guide, the document guides cannot be adjusted to less than A5
size.
• Make sure that the total height of the paper on the feed tray does not exceed 2 mm (0.08 in.). (This is
equivalent to about 20 sheets at 80 g/m² [21 lb.].)
6.3.3 Mixed Batch Card Guide (ADF)
39
To Next Page
Loading...
