7.11.7. PAPER SENSOR..... “OUT OF PAPER”
The Sensor detects the recording paper are in place.
When the recording paper is detected, the shelter plate let the sensor light passing through, the photo-transistor turns ON, and the
input signal of IC605-35 pin becomes a low level.
When there is no recording paper, the shelter plate closes the sensor light, the photo-transistor turns OFF, and the input signal of
IC605-35 pin becomes a high level.
[Paper Sensor]
Photo-transistor Signal (IC605-35 pin)
Recording Paper Set OFF Low level
No Recording Paper ON High level
7.11.8. PAPER EXIT SENSOR..... “PAPER JAMMED”
The sensor detects whether the recording paper exit out or noy.
When there is no recording paper at the position of the sensor, the shelter plate closes the sensor light, the photo-transistor fot
tarus OFF, and the input signal of IC605-4pin becomes high level.
When the recording paper reach the exit sensor, the shelter plate let the sensor light passing through, the photo-transistor ON, and
the input signal of IC605-4pin becomes a low level.
[Exit Sensor]
Photo-transistor Signal (IC605-4 pin)
No Paper OFF High level
Paper Exist ON Low level
179
KX-FL612CX / KX-FL612CX-S
To Next Page
Loading...
