Conditions Note
Call Duration timers can be programmed individually as follows:
(1). Extension-CO/Extension Duration Time (x60s)
(2). CO-CO Duration Time (x60s)
• While the timer in (1) is in
operation, if the communication
changes to a Trunk-to-Trunk
call, the timer in (1) continues
and the timer in (2) starts to
operate simultaneously.
• The timer in (1) can be set to
none (no limit).
• The timer in (2) does not start
when the incoming or outgoing
trunk is a SIP trunk.
Once a call duration timer starts, it continues even if the call is on
hold, the held call is retrieved by another extension, or transferred to
another extension.
If the call is parked, a call
duration timer is stopped. After
the call is retrieved, the timer is
reset. (Refer to 3.7 Holding
Features)
PIL Reference
2.2.5 PBX Configuration—[1-5] System—Timers
2.3.1 PBX Configuration—[2-1] Extension—Port
3.4.5 Extension Dial Lock
Description
[Local Dial Lock]
Executes Dial Lock (Local Dial Lock) for the extension using a PIN for each extension. It is possible to set
individually for each user using the feature number.
By the user operates Dial Lock, the Operating extension can be set to the pre-programmed TRS level.
(Refer to 3.4.1 Toll Restriction (TRS))
Using this method, an outgoing call cannot be made from that extension.
[Remote Dial Lock]
It is possible for Installer to execute Dial Lock (Remote Dial Lock) for other extensions through Web
Maintenance Console.
Operation
[Extension PIN Set / Cancel]
Dial the Extension PIN Set / Cancel feature number and enter a predetermined parameter. The extension
PIN can be set 4-10 digits. After hearing a confirmation tone, Set / Cancel the Extension PIN.
(Refer to 2.1.1 Feature Number Lists for User)
[Extension Dial Lock Set/Cancel]
Dial the Extension Dial Lock Set / Cancel feature number and enter a predetermined parameter. After
hearing a confirmation tone, Set / Cancel Extension Dial Lock.
(Refer to 2.1.1 Feature Number Lists for User)
3.4.5 Extension Dial Lock
48 Feature Manual
To Next Page
Loading...
