7.
a. Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
b. Click INS.
*1
When "En-bloc" is selected, you need to press "#" after dialing the phone number.
Programming for the Extension Number Method
1.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the small PBX image
for virtual slots.
c. Click Select Shelf.
d. Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
e. Click Port Property.
Confirm that all ports are in service (INS).
Note
When a V-IPGW16 card is installed, 8 ports (1–8)
are available. When two V-IPGW16 cards are
installed, 16 ports (1–16) are available.
2.
a. From the system menu, click CO & Incoming Call.
b. Click CO Line Settings.
c. Type the CO Name and assign an unused Trunk
Group Number to be used for all IP CO lines.
d. Click OK.
44 IP Networking Guide Document Version 2010-08
4.2.3 Programming the Network Settings
To Next Page
Loading...
