Continued from previous page
To the VLAN settings
To end programming
To set VLAN parameters
OR
Press STORE.
The IP-PT will reboot
and can then be
registered to the PBX.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Note
To confirm the connection to the secondary PBX after programming, (1) turn the IP-PT’s power off,
and (2) hold the STORE button and 2 key while turning the power on.
58 IP Networking Guide Document Version 2010-08
4.5.1 Assigning the IP Addressing Information
To Next Page
Loading...
