KX-NT265 (software version 2.00 or later only)
IP Address*
1
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address (if required)
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
Press VOLUME to
select "Network".
Press SP-PHONE. Press VOLUME to
select "DHCP (Disable)".
Press SP-PHONE
twice.
Press SP-PHONE.
Press VOLUME to
select "Subnet Mask".
Press SP-PHONE. Press SP-PHONE.
Press VOLUME to
select "Default GW".
Press SP-PHONE. Press SP-PHONE.
To the VLAN settings
To end programming
To set VLAN parameters
OR
Press STORE.Press HOLD to return
to the Menu screen.
HOLD
Press HOLD to return
to the Menu screen.
HOLD
The IP-PT will reboot
and can then be
registered to the PBX.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Document Version 2010-08 IP Networking Guide 59
4.5.1 Assigning the IP Addressing Information
To Next Page
Loading...
