Panasonic KX-NCP500 - 2.1.2 Maximum Values

2.1.2 Maximum Values
Throughout this manual, maximum entry values are shown for each programming item, as shown in the
example below.
Disable/
Enable
SELECT
[351]
Carrier Table No.
Trunk Group No.
END
ENTER ENTER
SELECT
01–10 01–64
However, please note that slot and port entry values are not listed within each programming item. These values
vary depending on the model of PBX and the card type installed, as shown below.
Available Slot Entry Values
PBX Model Free Slot Number Supported Cards
KX-NCP500 01–05
All cards
KX-NCP1000 01–07
Enter slot numbers as two-digit numbers (e.g. "04" for slot 4).
Available Port Entry Values
Card Type Port Number Related Programming
BRI2 01–02 [400] [409] [42x] [450]
DHLC4 01–04
[600] [601]DLC8 01–08
DLC16 01–16
DPH2 11–32
*1
[72x]
DPH4 11–34
*1
LCOT4 01–04 [400] [409] [41x] [450]
Enter values as two-digit numbers (e.g. "04" for port 4).
*1
Enter card number and port number as single-digit numbers (e.g.
"34" for card 3, port 4).
PT Programming Manual 21
2.1.2 Maximum Values