3. In PBX Setting:
a. Specify
a Site name if Master was selected for PBX
Type in step 2.
b. Select a Time Zone from the drop-down list.
c. Click the Local Time box and select the date and
time from the menu.
d. Click Next.
4. In LAN
Setting, the IP addresses for the PBX, DNS server, and DSP cards can be assigned automatically
through a DHCP server or entered manually.
When using a DHCP server:
a. Select Obtain an IP address automatically.
b. Select Obtain
DNS server address automatically.
c. Select Obtain DSP IP address automatically.
Notice
The boxes will turn grey and the IP address
information will be assigned automatically.
Write
down the address information assigned to
the PBX for future reference.
d. Click Next.
When not using a DHCP server:
a. Select Use the following IP address.
b. Enter an IP address
*1
, Subnet Mask
*2
, and Default
Gateway
*1
. (The default gateway may not need to be
specified depending on your network configuration.)
c. Select Use the following DNS server address.
d. Enter the preferred and alternative DNS IP
addresses
*1
.
e. Select Use the following DSP IP address.
f. Enter up to 2 IP addresses
*1
for each installed DSP
card.
g. Click Next.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255
"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
Getting Started 29
4.1.1 Easy Setup Wizard
To Next Page
Loading...
