5. In Registration Setting, the IP Terminal Registration Mode and the One Look Networking (Trial
Activation Key) can be set.
a. Select the IP Terminal Registration Mode:
• Manual: Select this mode to manually register
IP terminal information.
• Full Automatic: Select this mode to
automatically register IP terminal information.
• Extension Number Input: Select this mode to
automatically register IP terminal information
except its extension number. The extension
number can then be registered from the IP
telephone manually.
Note
• Full Automatic and Extension Number Input
registration methods may not be available
for certain types of IP terminals. In such
cases, select the Manual registration
method.
• For more information about the IP terminal
registration modes, refer to
"4.3.2 Registering IP Telephones
".
b. For One Look Networking (Trial Activation Key),
specify whether to activate the 60-day One-look
Networking Trial Activation Key.
– If Active is selected, the 60-day trial will begin
when the Easy Setup Wizard is completed.
– If Non Active is selected, you will have to
activate the trial manually in order to use
One-look Networking Features on a trial basis.
c. Click Next.
If Slave has been selected in step 2, the Easy Setup
Wizard will finish at this step. If LAN settings have
been changed from their default values in step 4, you
will be prompted to restart the PBX. Click OK to
restart the PBX. Otherwise, the login screen will be
displayed.
To add the PBX as a Slave unit PBX to the One-look
network, use the Add Site Wizard from the Master
unit PBX’s Home Screen.
30 Getting Started
4.1.1 Easy Setup Wizard
To Next Page
Loading...
