Note
By
assigning the PBX’s IP address to one IP-PT, it is possible to assign the PBX’s IP address to other
IP-PTs or IP-CSs on the same LAN through system programming. For details, refer to "9.14 PBX
Configuration—Configuration—Slot—V-IPEXT32—Port Property—Option—
ANNOUNCE Mode" in
the PC Programming Manual.
KX-NT300 series (except
KX-NT321)
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
ENTER
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address
Select "Default Gateway".
ENTER
Default Gateway Address*
3
ENTER
ENTER
Subnet Mask Address*
2
ENTER
Select "Subnet Mask".
Select "IP Address".
To start programming
Press
"SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Select "PBX".
Return to the
Menu screen.
PBX IP Address
ENTER
ENTER
To enter the IP address of the PBX
Select "PBX IP
Address".
Select "Primary
PBX".
ENTER
ENTER
Software version 2.00 or later only
Continued on next page
To Next Page
Loading...
