Panasonic KX-NS300 - Page 41

KX-NT300 series (except KX-NT321) and KX-NT500 series (except KX-NT511 and
KX-NT551)
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
ENTER
To set the IP address of the IP-PT
Select "Default Gateway".
ENTER
Default Gateway Address*
3
ENTER
To set the default gateway address (if required)
To set the subnet mask address
Select "Subnet Mask".
ENTER
Subnet Mask Address*
2
ENTER
Select "IP Address".
To start programming
Press "SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Press "STORE".
STORE
To end programming
The IP-PT will reboot
and can then be
registered to the PBX.
Return to the
Menu screen.
Return to the
Menu screen.
To enter the IP address of the Secondary PBX
(optional for KX-NT300 series [Software version 2.00 or later only] and
KX-NT500 series [Software version 1.00 or later only])
PBX IP Address
ENTER ENTER
Select "PBX".
Select "PBX IP
Address".
ENTER ENTER Select "Secondary
PBX".
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Getting Started 41
4.3.1 Assigning IP Addressing Information