Panasonic KX-TG1032C

Preparation
13
Display
Handset display items
Setting up the unit
before use
Display language
You can select either “English” or
“Français” as the display language.
The default setting is “English”.
1 {MENU}
2 {V}/{^}: “Handset settings” i
{OK}
3 {V}/{^}: “Display settings” i
{OK}
4 {V}/{^}: “Change language” i
{OK}
5 {V}/{^}: Select the desired setting.
6 {OK} i {OFF}
Note:
LHow to change from French back to
English:
1 {MENU}
2 {V}/{^}: “Param.combiné” i
{OK}
3 {V}/{^}: “Affichage” i {OK}
4 {V}/{^}: “Changer langue” i
{OK}
5 {V}/{^}: “English” i {OK} i
{OFF}
Voice guidance language
You can select either “English” or
“Français” as the voice guidance
language of the answering system. The
default setting is “English”.
1 {MENU}
2 {V}/{^}: “Answering device” i
{OK}
3 {V}/{^}: “Settings” i {OK}
4 {V}/{^}: “Voice prompt” i {OK}
5 {V}/{^}: Select the desired setting.
6 {OK} i {OFF}
Dialing mode
If you cannot make calls, change this
setting according to your telephone line
service. The default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 {MENU}
2 {V}/{^}: “Set tel line” i {OK}
3 {V}/{^}: “Set dial mode” i
{OK}
4 {V}/{^}: Select the desired setting.
5 {OK} i {OFF}
Displayed
item
Meaning
w Within range of the
base unit
LWhen flashing:
Handset is
searching for base
unit. (out of range of
base unit, handset is
not registered to
base unit, no power
on base unit)
5 Battery level
Example:
[1]
The handset’s
extension number
(example shown here:
handset 1)
In use Line or answering
system is being used
by another handset or
the base unit.
TG103xC.bookPage13Wednesday,February28,20075:25PM