Panasonic KX-TG2873BXS

61
KX-TG2873BXS/KX-TGA280BXS
12.4. Batch file Settings
Note:
• “****” varies depending on the country.
12.5. Commands
See the table below for frequently used commands.
Command name Function Example
getver Check software version Type "getver", then registered software version is read
out.
readid Read ID (RFPI) Type "readid", then registered ID is read out.
bandgap Check VDD adjustment parameter
value
Type "bandgap", then registered bandgap adjust value
is read out.
bandgap nn Set VDD voltage adjustment parame-
ter value
Type "bandgap nn", nn is an adjustment setting
value of the bandgap voltage.
conttx Set RFC (burst mode) Type "conttx", then set RF-burst mode.
setfreq Check frequency adjustment parame-
ter value
Type "setfreq", then registered freq adjustment value is
read out.
setfreq nn Set frequency adjustment parameter
value
Type "setfreq nn", nn is an adjustment setting value of
the frequency.
eeprom_hs_init Set default data to the EEPROM (cord-
less handset)
Type "eeprom_hs_init", then default data resistred.