17
Programmable Settings
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Date and Time
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter “0100”, and select “PM”
.)
1 Press [FUNCTION/EDIT].
2 Scroll to “Date and time” by pressing []
or [], then press [].
3 (1) Enter 2 digits each for month, day and
year. (Ex. To set Apr. 7, 2003, enter
“04 07 03”.)
(2) Enter 4 digits for time (hour and minute).
(Ex. To set 9:30, enter “0930”.)
• If you enter a wrong number, press [] or [] to
move the cursor to the incorrect number. Enter
the correct number.
4 Select “AM” or “PM” by pressing [].
5 Press [] (Save).
• If 3 beeps sound, the setting is not correct. Start again from step 3.
• The clock starts working.
6 Press [STOP].
If a power failure occurs, the time setting may be incorrect. When “” flashes
on the base unit display, adjust the date/time.
For Caller ID service users (p. 29)
• Caller ID information will reset the clock after the first ring if the adjusted time is
incorrect.
• If the time has not previously been set, the Caller ID information will not adjust
the clock.
• Caller ID information will automatically adjust the clock for daylight saving time.
Base Unit
▼
To Next Page
Loading...
