Programmable Settings
18
Dialing Mode (use either or )
If you have touch tone service, set to “Tone”. If rotary or pulse service is used, set
dialing mode to “Pulse”. The factory preset is “Tone”.
: Press [CONF/FUNCTION], and follow steps 2 to 5 above, using
the handset. Press the soft key (
), then press [OFF].
Line Mode (use either or )
The line mode is preset at the factory to “B”. Generally leave the line mode to “B”. If
a change of the line mode setting is required by our customer call center or
serviceman, change the line mode to “A”.
: Press [CONF/FUNCTION], and follow steps 2 to 5 above, using
the handset. Press the soft key (
), then press [OFF].
1 Press [FUNCTION/EDIT].
2 Scroll to “Initial setting” by pressing
[] or [], then press
[]
.
3 Scroll to “Set tel line” by pressing [] or
[], then press
[]
.
4 Press
[]
at “Set dial mode”.
5 Select “Pulse” or “Tone” by pressing [] or
[].
6 Press [] (Save), then press [STOP].
1 Press [FUNCTION/EDIT].
2 Scroll to “Initial setting” by pressing
[] or [], then press
[]
.
3 Scroll to “Set tel line” by pressing [] or
[], then press
[]
.
4 Scroll to “Set line mode” by pressing []
or [], then press
[]
.
5 Select “A” or “B” by pressing [] or [].
6 Press [] (Save), then press [STOP].
Base Unit
To Next Page
Loading...
