Special Features
48
Using the PAUSE Button
(For PBX Line/Long Distance Calls)
We recommend you press [PAUSE/REDIAL] if a pause is required for dialing with a
PBX or to make a long distance call.
Ex. Line access number [9] (PBX)
[9] [PAUSE/REDIAL]
• Pressing [PAUSE/REDIAL] once creates a 3.5 second pause. This prevents
misdialing when you redial or dial a stored number.
• Pressing [PAUSE/REDIAL] more than once increases the length of the pause
between numbers.
FLASH Button
Pressing [FLASH/CALL WAIT] also allows you to use special features of your host
PBX such as transferring an extension call or accessing optional telephone
services such as call waiting.
• Pressing [FLASH/CALL WAIT]
cancels the Temporary Tone Dialing mode or the
mute (p. 47).
Selecting the flash time (use either or )
The flash time depends on your telephone exchange or host PBX.
You can select the following flash times: “700, 600, 400, 300, 250, 110, 100 or 90
ms (milliseconds)”. The factory preset is “700 ms”.
• If the unit is connected via a PBX, PBX functions (transferring a call etc.) might not
work correctly. Consult your PBX supplier for the correct settings.
: Press [CONF/FUNCTION], and follow steps 2 to 5 above, using
the handset. Press the soft key (
), then press [OFF].
1 Press [FUNCTION/EDIT].
2 Scroll to “Initial setting” by pressing
[] or [], then press
[]
.
3 Scroll to “Set tel line” by pressing [] or
[], then press
[]
.
4 Scroll to “Set flash time” by pressing []
or [], then press
[]
.
5 Select the flash time by pressing [] or [].
6 Press [] (Save), then press [STOP].
Handset
To Next Page
Loading...
