Answer by voice command
T
his feature allows you to answer incoming calls
automatically with your voice. When your voice is
detected, answered calls will automatically be
directed to the speakerphone mode. The default
setting is “Off”.
Important:
R Before using this feature, we recommend that
you test it and adjust the voice command
sensitivity as needed.
R For best performance, answer the call within a
range of 50 cm (20 inches) to 1 m (40 inches).
R Once this feature is turned on, the Talking Call
Display will be activated automatically. To turn
off the Talking Call Display feature, see
page 36.
R Ambient noise (dog barking, TV sound, etc.)
may cause the unit to answer an incoming call.
R When this feature is used, the unit disconnects
the call automatically after 3 minutes. You may
hear a warning tone and the unit may prompt
you to press * to continue talking 1 minute
before disconnecting.
R Once you press any key during a call, the call is
continued.
Note:
R When a call is manually answered using a unit,
voice detection will end, and the answer by
voice command feature stops operating.
R This feature is not available while baby monitor
is set to “On” (page 41).
Turning answer by voice command on/off
Handset
1 Press and hold * for about 2 seconds.
2 MbN: Select the desired setting. a MSAVEN
R If you selected “Off”, go to step 4 to exit.
3 MYESN a The unit will display and announce
the voice command guidance.
R We recommend answering calls as
demonstrated.
R There must be a 1 second pause between
the two phrases.
4 To stop: Press MSTOPN.
To playback: Press MYESN.
To exit: Press MOFFN.
Note:
R I
f you wish to turn on answer by voice command
feature, select “Tone 1” to “Tone 5” as your
ringer tone (page 36). If another ringer tone is
selected, the unit will automatically use “Tone
1” as the default ringer tone.
Answer by voice command sensitivity
Y
ou can adjust the sensitivity of the answer by
voice command. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
Handset
1 MM
ENUN#107
2 MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering calls
Handset / Base unit
1 W
hen the unit rings, speak clearly as
demonstrated by the voice guidance. Refer to
step 3, “Turning answer by voice command on/
off”, page 21.
2 When you finish talking, press MOFFN on the
handset or MZN on the base unit.
Note for base unit:
R In step 1, you need to answer a call while the
base unit is not ringing or not announcing caller
information.
For assistance, visit www.panasonic.ca/english/support
21
Answer by Voice Command
To Next Page
Loading...
