Panasonic KX-TGF872C - Unit Registration and Management; Operating Additional Units; Registering and Deregistering Units

– To answer the call with the base unit, press
MZN
3 times.
*1
*1 If MMUTEN is pressed, press MZN 2 times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
T
he default handset name is “Handset 1” to
“Handset 6”. You can customize the name of
each handset (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 43).
Handset
1 MM
ENUN#104
2 Enter the desired name (10 characters max.).
a MSAVEN a MOFFN
Displaying the handset name
Y
ou can select whether or not the handset name
is displayed in standby mode. The default setting
is “Off”.
Handset
1 MM
ENUN#105
2 MbN: Select the desired setting. a MSAVEN
a MOFFN
Registering a unit
Operating additional units
Additional handsets
U
p to 6 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a h
andset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1 Handset:
MMENUN#130
2 Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
3 Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A
handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
Handset / Base unit
1 MM
ENUN#131
R All handsets registered to the base unit are
displayed.
2 MbN: Select the handset you want to cancel.
a MSELECTN
3 MbN: “Yes” a MSELECTN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
For assistance, visit www.panasonic.ca/english/support
43
Programming
TGF87xC_(en)_0204_ver031.pdf 43 2020/02/04 9:33:44