Panasonic KX-TGF872C - Error Messages and Solutions; Troubleshooting Common Errors

4 M
ount the unit on a wall then slide down to
secure in place.
R This product is compliant with the following
wall phone plate sizes (2 types).
1
83 mm (3
1
/4
inches)
2
102 mm (4 inches)
F
it the slots of the unit onto the
corresponding wall phone plate tabs for
(
3
) and (
4
) respectively.
1 2
3
4
4
3
Charger
D
rive the screws (
1
) (not supplied) into the wall.
2
27.2 mm (1
1
/1
6 inches)
1
2
Error messages
Display message Cause/solution
Ask phone
c
ompany for
VM access #
R Y
ou have not stored the voicemail access number. Store the
number (page 53).
Main unit no power
o
r
No link. Re-
connect base
AC adaptor.
R C
onfirm the base unit’s AC adaptor is connected to the unit and
the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been cancelled. Re-register
the handset (page 43).
Busy
R T
he called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the base unit. Move
closer and try again.
R The automated call block function is in operation. Try again later.
R One of the units is screening for telemarketing call. Try again later.
R One of the units is recording a conversation with outside caller.
Try again later.
For assistance, visit www.panasonic.ca/english/support
55
Useful Information
TGF87xC_(en)_0204_ver031.pdf 55 2020/02/04 9:33:45