Panasonic KX-TGF872C - Baby Monitor Configuration; Managing Monitoring Numbers and Sensitivity; Answering Monitored Calls

Handset
n F
rom the phonebook:
1 MMENUN#268
2 MbN: “On” a MSELECTN
3 MbN: Select “Outgoing call” to monitor
from outside. a MADDN
4 MbN: “Phonebook” a MSELECTN
5 MbN: Select the phonebook entry. a MSAVEN
R “Baby monitor” will be displayed.
Note:
R If you edit a phonebook entry which is assigned
for monitoring, the edited entry does not transfer
to the monitor.
n By entering phone numbers:
1 MMENUN#268
2 MbN: “On” a MSELECTN
3 MbN: Select “Outgoing call” to monitor
from outside. a MADDN
4 MbN: “Manual” a MSELECTN
5 Enter the desired name. a MOKN
6 Enter the desired number. a MOKN a
MSELECTN
R “Baby monitor” will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
T
he monitored handset cannot be used while baby
monitor is set to “On”.
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MSELECTN
3 MbN: “Off” a MSELECTN a MOFFN
Editing an outside monitoring number
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MSELECTN
3 MbN: “On” a MSELECTN
4 MbN: Select the outside line. a MMENUN
5 MbN:
“Edit” a MSELECTN
6 Edit the name if necessary. a MOKN
7 Edit the phone number if necessary. a MOKN
a MSELECTN
Erasing an outside monitoring number
Handset
1 Press MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MSELECTN
3 MbN: “On” a MSELECTN
4 MbN: Select the outside line. a MMENUN
5 MbN: “Erase” a MSELECTN
6 MbN: “Yes” a MSELECTN a MOFFN
Baby monitor sensitivity
Y
ou can adjust the sensitivity of the baby monitor.
Increase or decrease the sensitivity to adjust the
sound level needed to trigger the baby monitor
feature.
R This feature cannot be set during a monitoring
call.
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “Sensitivity level” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering the baby monitor
Handset / Base unit
n W
hen monitoring with a unit:
Handset: Press M
N to answer a call.
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom feature
is set to “On” (page 22).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press M N.
42
For assistance, visit www.panasonic.ca/english/support
Programming
TGF87xC_(en)_0204_ver031.pdf 42 2020/02/04 9:33:44