n B
y entering a phone number:
1 MMENUN#338
2 MbN: “Notification to” a MSELECTN
a MEDITN
3 Enter the desired name (16 characters
max.). a MOKN
4 Enter the desired number (24 digits max.).
a MOKN a MSELECTN a MEXITN
Turning on/off the new message alert setting
Handset / Base unit
1 MM
ENUN#338
2 MbN: “On/Off” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Editing the set phone number
Handset
1 MM
ENUN#338
2 MbN: “Notification to” a MSELECTN
3 MMENUN a MbN: “Edit” a MSELECTN
4 Edit the name if necessary (16 characters
max.). a MOKN
5 Edit the phone number if necessary (24 digits
max.). a MOKN a MSELECTN a MOFFN
Base unit
1 MM
ENUN#338
2 MbN: “Notification to” a MSELECTN a
MEDITN
3 Edit the name if necessary (16 characters
max.). a MOKN
4 Edit the phone number if necessary (24 digits
max.). a MOKN a MSELECTN a MEXITN
Erasing the set phone number
Handset
1 MM
ENUN#338
2 MbN: “Notification to” a MSELECTN
3 MMENUN a MbN: “Erase” a MSELECTN
4 MbN: “Yes” a MSELECTN a MOFFN
R The new message alert setting is turned off.
Base unit
1 MM
ENUN#338
2 MbN: “Notification to” a MSELECTN a
MERASEN
3 MbN: “Yes” a MSELECTN a MEXITN
R The new message alert setting is turned off.
Activating/inactivating the remote access code
t
o play messages
If you activate this feature, you must enter the
remote access code (page 51) to play the new
message from the new message alert call. This is
so that unauthorized parties cannot listen to your
messages. The default setting is “Inactivate”.
– “Inactivate”: You can listen to the message
by pressing 4 to play new messages (without
entering the remote access code).
– “Activate”: You must enter your remote
access code and then press 4 to play new
message.
Handset / Base unit
1 MM
ENUN#338
2 MbN: “Remote code” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Listening to messages
After you answer the new message alert, you can
listen to the messages as follows.
n When the remote access code is set to
“Inactivate”:
Press 4 to play the new message during the
announcement.
n When the remote access code is set to
“Activate”:
1 Enter the remote access code (page 51)
during the announcement.
2 Press 4 to play the new message.
Note:
R Within 10 seconds after listening to new
messages, you can press #9 during the call
to turn off the new message alert by a call
feature.
50
For assistance, visit www.panasonic.ca/english/support
Answering System
To Next Page
Loading...
