6 Before Leaving Your Desk
6.1 Call Forwarding/Do Not Disturb
You can have incoming calls automatically forwarded to another destination. You can
also have incoming calls rejected (Do Not Disturb).
Note
• Do Not Disturb is available only when connected to a KX-TGP600.
To access the FWD/DND settings
[In standby mode]
1. KX-TPA60/KX-TPA65:
/[FUNC]/[FUNCTION] ("FWD/DND"
*1
).
KX-TPA68:
Display the page 1 screen.
*2
"FWD/DND"/" "
2. If the unit has multiple lines, press [
] or [ ] to select the desired line.
3. [ ]/[ ]: Select the type of FWD or DND setting to apply.
The settings are as follows:
• DND: Enable Do Not Disturb
*3
(All incoming calls are automatically rejected.)
• Fwd(All): Enable Forward All Calls
(All incoming calls are forwarded.)
• Fwd(Busy): Enable Forward Busy
(Incoming calls are forwarded only when your extension is in use.)
• Fwd(NA): Enable Forward No answer
(An incoming call is forwarded if you do not answer the call within a certain
amount of time.)
4. If a Forward setting is selected, enter a new forward destination number, or confirm
and modify a previously set forward destination number.
*1
"Call Forward" when connected to a base unit other than the KX-TGP600.
*2
See 2.4.2 Display (KX-TPA68), page 50.
*3
Only when connected to a KX-TGP600.
Note
• KX-TPA60/KX-TPA65:
When Call Forwarding and/or Do Not Disturb is enabled,
/Fwd and/or /DND
appears on the display in standby mode.
6 Before Leaving Your Desk
104
To Next Page
Loading...
