3. [ ]/[ ]: Select the desired setting.
*1
*1
When using a KX-TPA65/KX-TPA68, the volume can also be adjusted by using
/
[VOL].
Note
• You can press the [ ] key instead of performing steps 1 and 2.
• For details about setting the ringer pattern, see Incoming Option, page 148.
Adjusting the Ringer Volume or Turning the Ringer Off while Ringing
While receiving a call, do the following to adjust the ringer volume or turn the ringer off:
Note
• If you attach a headset while receiving an incoming call, the ring from the handset
does not switch to the headset. If you attach a headset before receiving an incoming
call, and headset ringer is set to "On", ringing will be heard from the headset.
To adjust the ringer volume
1. KX-TPA60/KX-TPA65:
[
]/[ ]: Adjust the volume.
*1
KX-TPA68:
/[VOL]: Adjust the volume.
2. KX-TPA60:
, / /[XFER/CLR]: Exit
KX-TPA65/KX-TPA68:
/[CANCEL], / /[TRANSFER/CLEAR]: Exit
*1
The adjusted volume level will also be used for subsequent calls.
When using a KX-TPA65, the volume can also be adjusted by using /[VOL].
To turn the ringer off
1.
2.6 Incoming/Outgoing Call Log
When connecting the desk phone and handset in parallel, the Incoming/Outgoing Call
Log is shared between the desk phone and handset. For details about parallel
connection settings, see 2.7 Parallel Mode (KX-TPA65/KX-TPA68), page 79.
Displaying the Incoming Call Log
[In standby mode]
1. [ ]/
2. KX-TPA60/KX-TPA65
2.6 Incoming/Outgoing Call Log
77
To Next Page
Loading...
