3. Click OK.
• If there are active ports, the System Administrator will be asked to either to continue or to cancel.
Select OK to continue, or Cancel to abort the operation.
4. Click OK when the VPS has been initialized.
Restart System
1. Select Restart System.
(You can click the icon in the toolbar instead of step 1 and 2.)
• If there are active ports, the System Administrator will be asked to either to continue or to cancel.
Select OK to continue, or Cancel to abort the operation.
2. Click OK when prompted to restart the VPS.
1.9.8 Utility—Diagnostic
– Codec/DSP Voice Path: diagnoses whether the voice path between Codec and DSP functions properly.
– Play/Record Voice Path: diagnoses whether the voice path in the playing/recording unit functions properly.
Follow the steps below for System Diagnostic:
1. Click Utility in the menu bar.
2. Select Diagnostic.
3. Select Codec/DSP Voice Path or Play/Record Voice Path.
• If there are active ports, the System Administrator will be asked to either to continue or to cancel. Select
OK to continue, or Cancel to abort the operation.
• Diagnosis starts.
4. Click OK when the diagnostic is completed.
1.9.9 Utility—Programmer Code
The System Administrator can change the programmer code that is needed to use KX-TVA Maintenance
Console.
Follow the steps below to change the programmer code:
1. Click Utility in the menu bar.
2. Select Programmer Code then the desired programming level (user or installer).
3. If the programmer code is already set, enter the old programmer code in Enter old programmer Code:.
4. Enter a new programmer code in Enter new programmer Code:.
5. Enter the new programmer code again in Confirm new programmer Code:.
6. Click OK.
1.9.10 Utility—Screen Customize
You can change the user level password and select which menu items are available to users when they access
the KX-TVA Maintenance Console using the user level programmer code.
1. Click Utility in the menu bar.
2. Select Screen Customize and User Level.
3. Select the desired tabs, and check the items that you want to be available to users when accessing the
KX-TVA Maintenance Console using the user level programmer code.
4. Click the Password tab and change the password if necessary.
5. Click OK.
Document Version 3.0 2010/06 Programming Manual 33
1.9.10 Utility—Screen Customize
To Next Page
Loading...
