217
9. Menu Guide
This changes the AF area display setting for when the Auto Focus Mode is set to [ ]
([49-Area]) or [ ], etc. ([Custom Multi]).
You can fine-adjust the focus manually during AF lock (when the following conditions are
met).
– When the Focus Mode is set to [AFS] and the shutter button is pressed halfway
– When [AF/AE LOCK] is pressed
Sets the display method of MF Assist (enlarged screen).
• Available settings vary depending on the lens used.
When an interchangeable lens having a focus ring (H-FS12060/H-FSA14140/H-FS1442A)
is used
When an interchangeable lens with no focus ring is used
Settings: [ON]/[OFF]
[AF Area Display]
[ON]
Displays AF areas on the recording screen.
• AF areas are not displayed when the default AF area setting is applied to
[ ] ([49-Area]) or [ ], [ ] or [ ] in [Custom Multi].
[OFF]
Displays AF areas on the recording screen for just a few seconds after you
start using them.
• Even when [ON] is set, the same operation as [OFF] is performed in the following cases:
– When recording motion pictures
– When recording 4K photos
– Creative Video Mode
[AF+MF]
[MF Assist]
[]The screen is enlarged by operating the lens or by pressing [ ] (2).
[]The screen is enlarged by operating the lens.
[] The screen is enlarged by pressing [ ] (2).
[OFF] The screen is not enlarged.
Not available in these cases:
• MF Assist is not displayed in the following cases:
– When recording motion pictures
– When recording with [4K Pre-Burst]
– When using the Digital Zoom
ヤヒ ヤビ
To Next Page
Loading...
