231
9. Menu Guide
This is a function to automatically turn the camera to sleep (power save) status or turn off
the viewfinder/monitor if no operation is performed for a set time. Reduces battery
consumption.
[Economy]
[Sleep Mode] Sets the amount of time until the camera is put into sleep.
[Sleep
Mode(Wi-Fi)]
Sets the camera to sleep 15 minutes after being disconnected from Wi-Fi.
[Auto LVF/
Monitor Off]
Sets the amount of time it takes for the viewfinder/monitor to turn off.
(The camera is not turned off.)
[Power Save LVF
Shooting]
Puts the camera into sleep when the recording screen is displayed using
automatic viewfinder/monitor switching.
• [Power Save LVF Shooting] does not operate when [Time] is set to [OFF].
[Time] Sets the amount of time until the camera is put into sleep.
[Display]
Sets the screen where the camera is put to sleep.
[Only Monitor Info.]:
Puts the camera into sleep only when the on-monitor recording
information screen is displayed. (P49)
[All Live View]:
Puts the camera into sleep from any screen during recording
standby.
• To recover from [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting], perform
one of the following operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
• To recover from [Auto LVF/Monitor Off], press one of the buttons.
Not available in these cases:
• [Economy] does not work in the following cases.
– When connecting to a PC or a printer
– When recording or playing back motion pictures
– During a slide show
– When recording with [4K Pre-Burst]
– When recording in [Multi Exp.]
– When using [Time Lapse Shot]
– When using [Stop Motion Animation] (when [Auto Shooting] is set)
– When recording with Live View Composite
– When using the HDMI output during recording
– When using the AC Adaptor (optional) and the DC Coupler (optional)
To Next Page
Loading...
