10. Using the Wi-Fi/Bluetooth function
280
Sending images to a smartphone
Preparations:
Install the “Image App” in advance. (P259)
1
Select the menu.
2
Select [Via Network] or [Direct], and connect. (P292, 293)
3
Select a device you want to connect.
4
Check the send settings, and select [Set].
• To change the send setting, press [DISP.]. (P279)
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images While Recording] or [Send Images Stored in the
Camera] > [Smartphone]
(On your smartphone)
When connecting with [Via Network]:
1 Turn on the Wi-Fi function.
2 Select the wireless access point.
3 Start “Image App”.
When connecting with [WPS Connection] in [Direct]:
1 Start “Image App”.
• Refer to the operating instructions for your smartphone for information about whether
it supports WPS.
When connecting with [Manual Connection] in [Direct]:
1 Turn on the Wi-Fi function.
2 Select the SSID that matches the one displayed on the screen of this unit.
3 Start “Image App”.
5
When [Send Images While Recording] has been selected
Take pictures. (P278)
When [Send Images Stored in the Camera] has been selected
Select the picture. (P279)
Not available in these cases:
• When [Auto Transfer] in [Bluetooth] is set to [ON], [Wi-Fi Function] is not available.
To Next Page
Loading...
