10. Using the Wi-Fi/Bluetooth function
298
[Wi-Fi Setup] Menu
Configure the settings required for the Wi-Fi function.
The settings cannot be changed when connected to Wi-Fi.
This sets the higher priority between the camera and smartphone to perform operations
during remote recording. (P267)
You can improve security by enabling password entry for a direct connection to a
smartphone.
• When [ON] is selected, you can also set up a connection by scanning a QR code.
Acquires or changes the “LUMIX CLUB” login ID. (P289)
You can set the workgroup.
To send images to a PC, a connection to the same workgroup as the destination PC is
required.
(The default setting is “WORKGROUP”.)
1 Press [MENU/SET].
2 Enter the workgroup of the connecting PC.
• For information on how to enter characters, refer to P64.
• To reset to the default setting, press [DISP.].
You can change the name (SSID) of this unit.
1 Press [DISP.].
2 Enter the desired device name.
• For information on how to enter characters, refer to P64.
• A maximum of 32 characters can be entered.
> [Setup] > [Wi-Fi] > [Wi-Fi Setup]
[Priority of Remote Device]
[Wi-Fi Password]
[ON] Connects the camera and a smartphone using an SSID and password. (P263)
[OFF] Connects the camera and a smartphone using an SSID. (P262)
[LUMIX CLUB]
[PC Connection]
[Device Name]
MENU
To Next Page
Loading...
