29
2. Getting Started/Basic Operations
Card access indicators
• During access (i.e., while the access lamp is lit up or [ ]/[ ] is displayed), do not turn
this unit off, remove the battery, card or disconnect the AC adaptor (optional).
Furthermore, do not subject the camera to vibration, impact or static electricity.
The card or the data on the card may be damaged, and this unit may no longer operate
normally.
If operation fails due to vibration, impact or static electricity, perform the operation
again.
Access lamp
Lights up while the card is being accessed
(during recording, deletion, formatting, etc.).
Access indication
Lights up red while an image is being recorded
to the card.
• With [Double Slot Function] in the [Setup] menu, you can set the way recording to the two card
slots is performed. (P242)
24
p
FHD
8bit
MOV
L
4:3
To Next Page
Loading...
