10. Using the Wi-Fi/Bluetooth function
306
You can change the name (SSID) of this unit.
1 Press [DISP.].
2 Enter the desired device name.
• For information on how to enter characters, refer to P64.
• A maximum of 32 characters can be entered.
To prevent incorrect operation and use of the Wi-Fi function by a third party and to protect
saved personal information, protect the Wi-Fi function with a password.
• Once a password is set, you are required to enter it each time you use the Wi-Fi function.
• If you forget the password, you can reset it with [Reset Network Settings] in the [Setup] menu.
Displays the MAC address and IP address of this unit.
• A “MAC Address” is a unique address that is used to identify network equipment.
• “IP address” refers to a number that identifies a PC connected to a network such as the
Internet. Usually, the addresses for homes are automatically assigned by the DHCP function
such as a wireless access point. (Example: 192.168.0.87)
[Device Name]
[Wi-Fi Function Lock]
[Setup]
Enter any 4-digit numbers as the password.
• For information on how to enter characters, refer to P64.
[Cancel] Cancel the password.
[Network Address]
To Next Page
Loading...
