66
Recording mode
Taking pictures after automatically setting the
aperture value and shutter speed
(Program AE Mode)
Recording mode:
Take pictures using automatic aperture values and shutter speed settings in accordance
with the brightness of a subject.
1
Set mode dial to [ ]
2
Press the shutter button halfway and
display the aperture value and shutter
speed value on the screen
Shutter speed
Aperture value
• If the aperture value and shutter speed flash red, you
do not have the correct exposure.
About Program Shift
The function for maintaining the same exposure (brightness) while changing the aperture
value and shutter speed combination is called “Program Shift”. You can use “Program
Shift” to take pictures by adjusting the aperture value and shutter speed even in Program
AE Mode.
Preparation
Set [Flash Mode] to [
] (Forced Flash Off). (→150)
1
Press the shutter button halfway and display the aperture value and shutter
speed value on the screen
• If the aperture value and shutter speed flash red, you do not have the correct exposure.
2
While the numeric values are displayed (approximately
10 seconds), rotate the control dial to change the
values using Program Shift
Program Shift indication
Shutter speed
Aperture value
8.05.64.0
250 125 60 30 15
• The operation can also be performed by rotating the control ring.
• To cancel Program Shift, either turn off the camera or rotate the control dial until the Program
Shift indication turns off.
• Program Shift can easily be canceled by setting a function button to [One Push AE].
(→48, 72)
To Next Page
Loading...
Need help?
General
