Preparation
Press [MENU/SET].
-
tp;:..-..
\!y.
LI
~~:~~n_~
Press
~/~
to select the items (year, month,
day, hour, minute or display sequence), and
press
AI"
to set.
®:
Time
at
the
home
area
@:
Time
at
the
travel destination (P58)
lID:
Cancel
without
setting the clock.
DPress [MENU/SET] to set.
• After completing the clock settings, turn the camera off.
Then turn the camera back
on,
switch to recording mode, and check that the display
reflects the settings that were performed.
• When [MENU/SET] has been pressed to complete the settings without the clock having
been set, set the clock correctly by following the "Changing the clock setting (In normal
picture
mode)"
procedure below.
1 Press [MENU/SET].
2 Press
j./T
to select [CLOCK SET].
3 Press
~
and then perform steps 3 and 4 to set the clock.
4 Press [MENU/SET] to close the menu.
•
You
can also set the clock
in
the [SETUP] menu. (P21)
flNote
• The clock is displayed when [DISPLAY]
is
pressed several times during recording.
• When a fully charged battery has been inserted for more than 24 hours, charging of the built-in
battery for the clock is completed so the clock setting will be stored (in the camera) for at least
3 months even if the battery is removed. (If you insert a battery that
is
not sufficiently charged,
the length of time that the clock setting
is
stored may become less.)
•
You
can set the year from 2000 to 2099. The 24-hour system is used.
•
If
the clock is not set, the correct date cannot be printed when you stamp the date
on
the
pictures with [TEXT STAMP] (P74) or order a photo studio to print the pictures.
• If the clock is set, the correct date can be printed even if the date is not displayed
on
the screen
of the camera.
VQT1M97 17
To Next Page
Loading...
Need help?
General
