Connecting
to
other equipment
Connecting
to
a
PC
You can acquire recorded pictures
to
a
PC
by connecting the
camera
and the PC.
•
You
can easily print out or mail the pictures you have imported. Use of the
"PHOTOfunSTUDIO-viewer-" bundled software
on
the CD-ROM (supplied) is a convenient
way of doing this.
Preparations:
Turn on the
camera
and
the
PC.
Remove the card before using the pictures in the built-in memory.
Connect the camera to a
PC
via the USB connection cable ® (supplied).
~=,::!::t====
.....
.t
I
® USB connection cable (supplied)
• Check the directions of the connectors, and plug them straight
in
or unplug them straight out.
(Otherwise the connectors may be bent out of shape which will cause trouble.)
® Align the marks, and insert.
©
AC
adaptor (DMW-AC5PP; optional)
• Use a battery with sufficient battery power or the
AC
adaptor (DMW-AC5PP; optional).
If
the
remaining battery power becomes low while the camera and the
PC
are communicating, the
status indicator blinks and the alarm beeps.
Refer to "Disconnecting the USB connection cable safely" (P84) before disconnecting the USB
connection cable. Otherwise, data may be destroyed.
SETii)
~USBMODE
,
..
, ,
..
, ,
SELECT':'
Press
J../~
to select [PC], and then press [MENUI
SET].
•
If
[USB MODE] (P24) is set to [PC]
in
the [SETUP] menu
in
advance, the camera will be automatically connected to the
PC
without displaying the [USB MODE] selection screen. Since there
is
no need to set this each time you connect to the
PC,
it
is
convenient.
• When the camera has been connected to the
PC
with
[USB MODE] set to [PictBridge(PTP)], a message may appear
on
the PC's screen. Select [Cancel] to close the screen, and
disconnect the camera from the
PC.
Then set [USB MODE] to
[PC] again.
VQT1M97 83
To Next Page
Loading...
Need help?
General
