Advanced (Playback)
3 Press
[MENU/SEn
to
close
the
menu.
-
You
cannot select [CANCEL] if not even one picture has been set for DPOF printing.
• To
print
the
date
After setting the number of prints, set/cancel printing with the recording date
by
pressing [DISPLAY].
- When you go to a photo printing store for digital printing, be sure
to
order the printing of the
date additionally if required.
- Depending
on
the photo printing store or the printer, the date may not be printed even if you set
to print the date. For further information, ask at your photo printing store or refer to the
operating instructions for the printer.
- The date cannot be printed on pictures stamped with text.
-If
you set [TEXT STAMP] for pictures that have been set for date printing, the date printing
setting
is
canceled.
flNote
- The number of prints can
be
set from 0 to 999.
- With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this
is
the case.
-It
may not be possible to use the DPOF print settings with other equipment.
In
this case, cancel
all the settings, and reset the settings.
-If
the file is not based
on
the DCF standard, the DPOF print setting cannot be set.
You can
set
protection for pictures you
do
not
want
to
be
deleted by mistake.
Select [PROTECT]
on
the
[PLAYBACK] mode menu. (P19)
Press
./.
to
select [SINGLE]
or
[MULTI] and
then
press
[MENU/SET].
[SINGLE]
.';
.-
:
..
:-:
,:: .
·s~L§£t~;0"<"<"*~.,~.P
[MULTI]
Select
the
picture,
and
then
press
[MENU/SET].
When [MULTI] has been selected
- Repeat these steps for each picture.
- The settings are canceled when [MENU/
SET] is pressed again.
Press
.....
/~
to
select
the picture.
Press [ill]
to
return
to
the
menu screen.
- Press [MENU/SET] to close the menu.
Press
A/T
/
.....
/~
to
select
the
pictures.
•
Canceling
all the [PROTECT]
settings
1
Select
[CANCEL]
on
the
screen
shown
in
step
2 and
then
press [MENU/SET].
2 Press A
to
select [YES] and
then
press
[MENU/SET].
VQT1M97
81
To Next Page
Loading...
Need help?
General
