Advanced (Playback)
91
VQT1F52
Press [ ] to display the [PLAY] mode
menu and select the item to set. (P76)
Usually, it is not necessary to format the
built-in memory and the card.
Format them when the message
[BUILT-IN MEMORY ERROR] or
[MEMORY CARD ERROR] appears.
Press 3 to select [YES] and then
press [MENU/SET].
(The illustration shows the screen when
the built-in memory is formatted.)
• When a card is not inserted, you can
format the built-in memory. When a
card is inserted, you can format the
card.
• If you press [MENU/SET] while
formatting the built-in memory, the
formatting will stop halfway. (However,
all the pictures will be deleted.)
• Formatting irretrievably deletes all the
data including any protected pictures.
Check the data carefully before
formatting.
• If the card has been formatted on a PC or
other equipment, format it on the camera
again.
• Use a battery with sufficient battery power
or the AC adaptor (DMW-AC5PP;
optional) when formatting.
• Do not turn the camera off during
formatting.
• It may take longer to format the built-in
memory than the card. (Max. about
15 sec.)
• You cannot format an SD Memory Card or
an SDHC Memory Card when the card’s
Write- Protect switch A is set to [LOCK].
• If the built-in memory or the card cannot
be formatted, consult your nearest
Service Center.
[FORMAT]
Initializing the built-in memory or a
card
MENU
/
SET
MENU
/
SET
2
For USA assistance, please call: 1-800-272-7033
or send e-mail to : digitalstillcam@us.panasonic.com
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or
send e-mail to: lumixconcierge@ca.panasonic.com
DMC-FX100ENG.book 91 ページ ２００７年５月１６日 水曜日 午後３時２２分
To Next Page
Loading...
Need help?
General
