Preparation
15
VQT1F52
Setting Date/Time
(Clock Set)
∫ Initial setting
The clock is not set so the following screen
appears when you turn the camera on.
A [MENU/SET] button
B Cursor buttons
C Mode dial
1 Press [MENU/SET].
2 Press 3/4/2/1 to select the
date and time.
A Time at the home area
B Time at the travel destination (P57)
• 2/1: Select the desired item.
• 3/4: Set the display order for the date
and time.
• : Cancel without setting the clock.
3 Press [MENU/SET] to set.
• Turn the camera off after setting the
clock. Then set the mode dial to a
recording mode to turn the camera on
and check whether or not the clock
setting is correct.
1 Press [MENU/SET].
2 Press 3/4 to select [CLOCK SET].
3 Press 1 and then perform steps
2 and
3 to set the clock.
4 Press [MENU/SET] to close the menu.
• You can also set the clock in the
[SETUP] menu. (P18)
• When a fully charged battery has been
inserted for more than 24 hours, charging
of the built-in battery for the clock is
completed so the clock setting will be
stored (in the camera) for at least
3 months even if the battery is removed.
(If you insert a battery that is not
sufficiently charged, the length of time that
the clock setting is stored may become
less.) However the clock setting is
canceled after this time. In this case, set
the clock again.
• You can set the year from 2000 to 2099.
The 24-hour system is used.
• If the clock is not set, the correct date
cannot be printed when you stamp the
date on the pictures with [DATE STAMP]
(P82) or order a photo studio to print the
pictures.
OFF
ON
:
:
Changing the clock setting
DMC-FX100ENG.book 15 ページ ２００７年５月１６日 水曜日 午後３時２２分
To Next Page
Loading...
Need help?
General
