Advanced (Recording pictures)
50
VQT1F52
Press [ ] to display the [SCENE MODE]
menu and select a scene mode. (P46)
This takes pictures of a baby with a healthy
complexion. When you use the flash, the
light from it is weaker than usual.
You can set two different birthdays by using
[BABY1] and [BABY2]. You can display the
set age when playing back the pictures and
stamp the age on the recorded pictures
with [DATE STAMP] (P82).
• The age can also be printed on each
picture by using the software [LUMIX
Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] in the
CD-ROM (supplied).
∫ Age display setting
• To have the age displayed, first set the
birthday and then be sure to set
[WITH AGE] before taking the pictures.
∫ Birthday setting
1 Press 3/4 to select [BIRTHDAY SET.]
and then press [MENU/SET].
2 When a message appears, press 2/1
to select items (Year/Month/Day) and
then press 3/4 to set them.
3 Press [MENU/SET] to finish the setting.
• The focus range becomes the same as
macro mode. [5 cm (0.16 feet) (Wide)/
30 cm (0.98 feet) (Tele) to ¶]
• The ISO sensitivity becomes the same as
when Intelligent ISO sensitivity mode
[ ] is set to a highest ISO sensitivity of
[ISO400].
• If you turn on the camera in [BABY1]/
[BABY2], the age and current date and
time are displayed for about 5 seconds on
the bottom of the screen.
• The age display style differs depending on
the language setting in the recording
mode.
• If the age is not properly displayed, check
the clock and birthday settings.
• If the camera is set to [WITHOUT AGE],
the age is not recorded even if the time
and birthday are set. This means the age
cannot be displayed even if camera is set
to [WITH AGE] after taking the pictures.
• The birthday setting can be reset with
[RESET].
• You cannot use the following functions.
– [D.ZOOM]
– [SLOW SHUTTER]
Press [ ] to display the [SCENE MODE]
menu and select a scene mode. (P46)
Select this when you want to take pictures
of a pet such as a dog or a cat.
This allows you to set the birthday of your
pet. You can display the set age when
playing back the pictures and stamp the
age on the recorded pictures with [DATE
STAMP] (P82).
• The age can also be printed on each
picture by using the software [LUMIX
Simple Viewer] or
[PHOTOfunSTUDIO-viewer-] in the
CD-ROM (supplied).
Refer to [BABY1]/[BABY2] (P50) for
information about age display setting and
birthday setting.
• The initial setting for the AF assist lamp is
[OFF]. (P68)
• Refer to [BABY1]/[BABY2] for other
information about this mode.
[BABY1]/[BABY2]
1
2
MENU
/
SET
[PET]
MENU
/
SET
DMC-FX100ENG.book 50 ページ ２００７年５月１６日 水曜日 午後３時２２分
To Next Page
Loading...
